ANALISIS DISTRIBUSI TEMPERATUR GERAM PADA PROSES PEMBUBUTAN Ti-6Al-4V DENGAN FEM-SIMULATION MENGGUNAKAN SOFTWARE AUTODESK SIMULATION MECHANICAL 2016

ZIKRI, BAHRAN and Mohruni, Amrifan Saladin (2016) ANALISIS DISTRIBUSI TEMPERATUR GERAM PADA PROSES PEMBUBUTAN Ti-6Al-4V DENGAN FEM-SIMULATION MENGGUNAKAN SOFTWARE AUTODESK SIMULATION MECHANICAL 2016. Undergraduate thesis, Sriwijaya University.

[img]
Preview
Text
RAMA_21201_03111405004_0011096407_01_front_ref.pdf - Accepted Version
Available under License Creative Commons Public Domain Dedication.

Download (9MB) | Preview
[img] Text
RAMA_21201_03111405004_0011096407_02.pdf - Accepted Version
Restricted to Repository staff only
Available under License Creative Commons Public Domain Dedication.

Download (438kB) | Request a copy
[img] Text
RAMA_21201_03111405004_0011096407_03.pdf - Accepted Version
Restricted to Repository staff only
Available under License Creative Commons Public Domain Dedication.

Download (395kB) | Request a copy
[img] Text
RAMA_21201_03111405004_0011096407_04.pdf - Accepted Version
Restricted to Repository staff only
Available under License Creative Commons Public Domain Dedication.

Download (733kB) | Request a copy
[img] Text
RAMA_21201_03111405004_0011096407_05.pdf - Accepted Version
Restricted to Repository staff only
Available under License Creative Commons Public Domain Dedication.

Download (52kB) | Request a copy
[img] Text
RAMA_21201_03111405004_0011096407_06_ref.pdf - Bibliography
Restricted to Repository staff only
Available under License Creative Commons Public Domain Dedication.

Download (83kB) | Request a copy
[img] Text
RAMA_21201_03111405004_0011096407_07_lamp.pdf - Accepted Version
Restricted to Repository staff only
Available under License Creative Commons Public Domain Dedication.

Download (439kB) | Request a copy

Abstract

Ti-6Al-4V is one of most-used-by material on Aviation Manufacture Industry because its high strength and high endurance when facing high temperature. Within its specialties it had, Ti-6Al-4V has classified to hard-to-machine material, because this material has low thermal conductivity at 6,7 W/moC. So when it machined, heat that had been generated in cutting process will be concentrated on lathe and not on chip. Because of this, Simulation had been made for Ti-6Al-4V, aiming to know temperature distribution generated on chip when turning on process. This simulation using cutting parameters which refers on previous research done by Soe, et al., ( 2012). Machining condition that has been using is Cutting Speed 150 m/min, feed rate 0,2 mm/rev, depth of cut 1 mm, and cutting length 9 mm. Simulation Result on this simulation process will be validated using previous research too see if there is difference on temperature distribution generated on chip on turning process of Ti-6Al-4V.

Item Type: Thesis (Undergraduate)
Uncontrolled Keywords: Temperature, Chip, Simulation, Ti-6Al-4V, Autodesk
Subjects: T Technology > TJ Mechanical engineering and machinery
Divisions: 03-Faculty of Engineering > 21201-Mechanical Engineering (S1)
Depositing User: Assoc.Prof Amrifan Saladin Mohruni
Date Deposited: 17 Jul 2019 04:26
Last Modified: 10 Dec 2019 07:53
URI: http://repository.unsri.ac.id/id/eprint/358

Actions (login required)

View Item View Item